Hello everyone!
There are two intermediate posts in the feed.
As the season comes to an end — just like the grip — it was decided to finalize the measurements for the end of 2025.
The engine with the full set of Etuners.parts was removed.
The new task is to increase the engine's efficiency.
It was decided to build the engine with a higher compression ratio of 10.5:1 and add a number of improvements.
Below are the details of the configuration.
🧠 Spec list
Engine:
2.0TFSI CYM (swap)
Pistons Etuners.Parts CR10.5:1
Connecting rods Etuners.Parts
Springs and retainers Etuners.Parts
Pump station for two pumps Etuners.Parts — fuel potential 1000+ hp (up to 1500 hp with pump replacement)
MAP sensor 5bar (intake manifold) — Etuners.Parts
MAP sensor 4bar (charge pipe) — Bosch
Intercooler DO88
Water injection system with alcohol AEM (injector 250cc)
Intake manifold CHHB (stock)
Fuel rail Etuners.Parts
Injectors Bosch 980cc x4
Insert in the fuel pump — Etuners.Parts
Fuel pump cover — Etuners.Parts
Boost pipes — tuned
Turbocharger ET600
Exhaust TT-RS Performance (stock)
Suspension and wheels:
KW Variant 3
Continental Sport Contact 7
ABT Forged wheels
Transmission:
DQ381 UAQ — stock
Reinforced clutch ET800
⚙️ Software
ECU — Etuners Stage 4 Custom:
* Ability to switch maps for any mode
* Control of methanol functions through the stock ECU
* Flex fuel — no need to flash anything, just fill it up, and everything adapts by itself
* Additional protection functions for EGT, detonation, and intake air temperature
TCU — Etuners Stage 3+ Custom:
A huge list of modifications, all aimed at implementing launch and special shifts without the amakh function, but with kicks at maximum RPM. This preserves the clutch at high torque and allows for many runs in a row without losing dynamics.
Measurements:
0-100 km/h 2.71s
100-200 5.22s
1/4 — 10.05
The result could have been under 10, but the gas
was released earlier than necessary.
Power measurement:
640 hp 800 Nm
💬 Please note, the measurements were performed on a regular road and road tires. This was the task, to make a fast car that can go fast immediately and without preparations on any surface on the edge of grip.
Our contacts (Moscow):
+74954813331
t.me/Etuners_AssistentBot
